and "right" bands.
1. Set up the desired configuration for both the "left" and "right" bands.
2. Press and hold in the one of the Hyper Memory keys ([A] ~ [F]) for 2 seconds to store into the Hyper Memory channel
which you wish to store that configuration.
3. Press the appropriate Hyper Memory Key [A] - [F] to recall the desired Hyper Memory channel. Please store the curre-
nt configuration into Hyper Memory Channel before recalling the Hyper Memory Channel to prevent the current config-
uration lost.
Memory Only Mode
When you store the memory channels, you may place the radio in a "Memory Only" mode, whereby VFO operation is im-
possible. This may be particularly useful during public-service events where a number of operators may be using the radio
for first time, and ultimate simplicity of channel selection is desired.
Procedure:
1. Turn the radio off.
2. Press and hold in the LEFT [V/M] while turning the radio on.
3. Rotate the DIAL knob to select the (F-5 M-ONLY MODE), then short press the [SET] key to confirm. The radio will res-
tart and enter Memory Only Mode.
4. To return to normal operation, repeat the above steps.
23
Some Advanced Features
Repeater Operation
The TH-7800 provides a convenient Automatic Repeater Shift feature, which causes the appropriate repeater shift to be
automatically applied whenever you tune into the designed repeater sub-bands in your country.
To activate ARS:
1. Short press the [SET] key to enter the Menu mode.
2. Rotate the "Main" band DIAL to select Menu # 2 (ARS).
3. Short press the "Main" band DIAL knob, then rotate the "Main" band DIAL to change the setting to "ON".
4. Short press the [SET] key to save the new setting and exit to normal operation.
If the ARS feature has been disabled, or if you need to set a repeater shift direction other than that established by the ARS,
you may set the direction of the repeater shift manually.
1. Short press the [SET] key to enter the Menu mode.
2. Rotate the "Main" band DIAL to select Menu # 24 (RPT.MOD).
3. Short press the "Main" band DIAL knob, then rotate the "Main" band DIAL to select the desired shift among "+", "-" and
"OFF".
4. Short press the [SET] key to save the new setting and exit to normal operation.
And when you travel to a different region, you may need to change the default repeater shift so as to ensure compatibility
with local operating requirements.
1. Short press the [SET] key to enter the Menu mode.
2. Rotate the "Main" band DIAL to select Menu # 27 (RPT.MOD).
3. Short press the "Main" band DIAL knob, then rotate the "Main" band DIAL to select the desired shift among "+", "-" and
"OFF".
4. Short press the [SET] key to save the new setting and exit to normal operation.
24