How To Use; Cleaning - Vornado ATH1 Owner's Manual

HOW TO USE

Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact
Vornado Air LLC at 1-800-234-0604.
1. Use integrated handle on the back of
heater for lifting and carrying.
2. Position heater so airflow is
not obstructed.
3. Plug power cord into standard
grounded wall outlet.
COOL DOWN
When you power off your heater, it
automatically enters a cool down
routine in which the heating element
turns off and the fan exhausts
remaining heat. During Cool Down,
the display counts down from eight,
then powers off completely.
10 English
4. Press power button and select Mode .
Next, set thermostat to desired temperature
using / . After selecting desired set
temperature, it will display for eight seconds
before returning to room temperature.
FAN CONTROL
Press to select either Continuous C or Auto
A. In Continuous mode C, the Fan will run
Continuously on high speed when High Heat H
is selected, or Continuously on low speed when
Low Heat L is selected.
In Auto mode A, the Fan speed will fluctuate to
efficiently maintain set temperature.

CLEANING

Because your heater moves a substantial amount of air, it will need regular cleaning. Cleaning the outside of the heater is recommended
on a bi-weekly basis. If service is required, return your heater to Vornado. See WARRANTY for instructions.
1. Unplug heater before cleaning.
2. Use brush attachment on
household vacuum cleaner
to vacuum any accumulated
dust off the Air Inlets on
side of heater.
You may also clean the heater
with high-pressured air, as well.
3. Use brush attachment on
household vacuum cleaner to
vacuum any accumulated dust off
Front Angled Outlet Grill.
4. Wipe down the entire heater
with soft cloth.
English
11