Cisco ASA 5585-X Quick Start Manual page 2

Cisco ASA 5585-X Quick Start Guide
1 Power Supply Module (PS0)
2. Connect the power cables to the electrical outlets.
3. Power on the ASA. If you have redundant power supplies, you must power on both modules.
4. Check the Power LED on the front of the ASA; the AC ON indicator should be green, the FAN ON indicator
should be green, and the OUT OK indicator should be off.
3. Network Considerations for Multiple SSPs
The ASA SSP resides in slot 0 (bottom). A second SSP (or network module) can be installed in slot 1 (top). When
you install a non-ASA SSP in slot 1, all non-management interfaces belong to the ASA in slot 0, while the
management interfaces belong to the module. If you install dual ASA SSPs, then they are completely independent
systems.
7
SFP1 SFP0
7
SFP1 SFP0
Default Configuration for Management
See the following table for default configurations for the Management interfaces depending on which module is
installed in slot 1. Note that the left-hand Management interface (when facing the back of the chassis) is not
configured by default.
1
Cisco ASA 1200W AC
100-240V
15.0/8.0.A
56/60Hz
Module Management 1/0
Default IP: Varies
6 5 4 3 2 1 0 1 MGMT
0 USB
6 5 4 3 2 1 0 1
MGMT 0 USB
ASA Management 0/0
Default IP: 192.168.1.1
2 Power Supply Module (PS1)
0
1
RESET
AUX CONSOLE
0
1
RESET
AUX CONSOLE
3. Network Considerations for Multiple SSPs
2
Cisco ASA 1200W AC
100-240V
15.0/8.0.A
56/60Hz
2