HQ Power vdpc174 User Manual page 8

• Deleting a Scene
1. Enable the PROGRAM mode.
2. Press the desired SCENE button to select the scene you wish to delete.
3. Press and hold down the AUTO / DEL button. While holding the button, tap the SCENE button that
corresponds with the scene you wish to delete.
4. When the programmed scene is deleted, all DMX channel values will be set to 0.
• Deleting All Scenes
1. With unit switched off, press and hold down the PROGRAM and bank DOWN buttons at the same time.
2. Turn the unit back on and all scenes should be cleared.
• Copying a Bank of Scenes
1. Enable the PROGRAM mode.
2. Tap the bank UP / DOWN button until you reach the bank you wish to copy.
3. Tap the MIDI / REC button.
4. Tap the bank UP / DOWN button to select the bank you wish to copy to.
5. Tap the MUSIC / BANK COPY button, all LEDs will briefly flash three times indicating the function has been
completed.
6. Press the PROGRAM button for three seconds to exit PROGRAM mode.
d. Chases
• Programming a Chase
Scenes must have been programmed in order to program a chase. This function allows you to cycle through up to
240 scenes in a preselected order. It is recommended to delete all chases in the controller before programming
chases for the first time. See "Deleting All Chases".
1. Enable the PROGRAM mode.
2. Tap the CHASE button to select the chase you wish to program.
3. Select a desired scene from the bank that has scenes stored inside it.
4. Tap the MIDI / REC button.
5. Repeat steps 3 to 4 until all desired scenes have been entered.
• Inserting a Bank of Scenes into a Chase
1. Enable the PROGRAM mode.
2. Select the chase you wish to program.
3. Use the bank UP / DOWN key to select the bank of scenes you wish to copy.
4. Tap the MUSIC / BANK COPY button.
5. Tap the MIDI / REC COPY button. All LEDs will flash three times indicating that the requested operation has
been performed.
• Adding a Step
1. Enable the PROGRAM mode.
2. Press the corresponding button to the chase you wish to add a step to.
3. Press the TAP / DISPLAY button, the LCD will show the current step.
4. Press the bank UP / DOWN button and scroll to the step you wish to insert the step after.
5. Press the MIDI / REC button. The segment display will read the step one step higher than before.
6. Tap the TAP / DISPLAY button again. The LCD shows the current chase, scene, and bank. Create a desired
scene and record it as a new step or select a previously programmed scene to add to the chase.
7. Once you have selected the scene you wish to add, press the MIDI / REC button again. All LEDs will flash
three times indicating the new step has been inserted into the chase.
VDPC174_v2 8 VELLEMAN