Page 1
EP-21F Manual Letter Folder Operation Manual EP Equipment...
Page 3
Introduction Thank you for selecting EP folder. This machine is designed for efficiently folding paper up to legal size (216×356mm). To ensure correct operation and avoid damage & injury, please read this operation manual thoroughly and familiarize yourself with its content, especially the section entitled “Safety Introductions”...
Contents Troubleshooting Safety Introductions...............4 Trouble Possible Cause Solution Cautions Before Installation............6 No power at present Check power. Machine does not Power cord not well Plug firmly work (count Specifications.................7 plugged display does Replace with fuse of the same not light up) Blown fuse type and rating Main Parts list ................8...
2.2 Push the fed roller shaft towards the right cover (near the control Safety Introductions panel). Always pay attention to the warnings and cautions displayed below to avoid human injury and property damage. ◆The degree of danger and damage that may occur is indicated on three levels by the following marks.
Page 6
● If any foreign objects such as metal or liquid enter this machine, Maintenance immediately turn off the power switch and disconnect the power plug from the power outlet, then contact your dealer. Turn off the power and cover the machine if left idle for a ╳...
4. Manual mode Cautions Before Installation Close the auxiliary fold table before use manual mode. 1. Power Supply ◆ Make sure the power supply used is always within the following range: DO NOT insert paper more than 3 sheets at a time. ●110V~120V AC 60HZ or 220V~240V AC 50HZ.
Take the sheets out of the ejection stack in time, so the stacked sheets won’t exceed the max line, which may cause Model EP-21F Manual Letter Folder jam. 4" x 5" to 8 1/2" x 14" Sheet size...
3.6 Press START/STOP button to run the machine. Machine will stop Main Parts list automatically if sheets run out. You can also press START/STOP button 1. Manual feed cover again to stop the machine at any time. 2. Right cover (near control panel) 3.
Control Panel DO NOT touch any moving parts during operation. DO NOT let long hair, necktie etc. hang above the machine or near to moving Parts. 3. Automatic mode 3.1 Turn on the power switch. 3.2 Position the fold stop referring to the folding instruction. 3.3 Pull the ejection tray out.
Correct Fold Misalignment. Installation 1. Install the upper plate Solution Insert the upper plate along the guide line as far as possible, and seats Fold type Misalignment (face the knob) on the the support pins A B at the cutout. CCW Upper knob A is longer Single...
1. Install the lower plate Operation 2.1 For single fold. Push fold stop to the end of C direction. Then insert the lower plate along 1. Connect the power supply. the guide line as far as possible, and seats on the support pins D E at the Connect the power cord to the inlet and outlet.
Need help?
Do you have a question about the EP-21F and is the answer not in the manual?
Questions and answers