Table of Contents
Advertisement
126 STARTING AND OPERATING
Normal Starting Procedure — Engine Manifold Air
Temperature Above 66° F (19° C)
Observe the instrument panel cluster lights when starting
the engine.
1. Always apply the parking brake.
2. Shift into PARK for an automatic transmission.
For vehicles equipped with a manual transmission, fully
press and hold the clutch pedal and shift into NEU-
TRAL.
3. Turn the ignition switch to the ON position and watch
the instrument panel cluster lights.
CAUTION!
If the "Water in Fuel Indicator Light" remains on, DO
NOT START the engine before you drain the water
from the fuel filters to avoid engine damage. Refer to
"Maintenance Procedures/Draining Fuel/Water Sepa-
rator Filter" in "Maintaining Your Vehicle" for further
information.
4. Turn the ignition switch to the START position and
crank the engine. Do not press the accelerator during
starting.
CAUTION!
Do not crank engine for more than 15 seconds at a time
or starter motor damage may result. Turn the ignition
switch to the OFF position and wait at least two
minutes for the starter to cool before repeating start
procedure.
5. When the engine starts, release the key fob.
6. Check that the oil pressure warning light has turned off.
7. Release the parking brake.
Starting Procedure — Engine Manifold Air
Temperature 0°F To 66°F (–18°C to 19°C)
NOTE: The temperature displayed in the instrument clus-
ter does not necessarily reflect the engine manifold air
temperature. Refer to "Instrument Cluster Display" in
"Understanding Your Instrument Panel" for further infor-
mation. When engine temperatures fall below 66°F (19°C)
the "Wait To Start Light" will remain on indicating the
intake manifold heater system is active.
Advertisement
Table of Contents
