Carrier Infinity 25VNA Installation Instructions Manual page 14

PRESSURE TRANSDUCER (SPT)
SUCTION TUBE
SUCTION THERMISTOR (OST)
ACCUMULATOR
REVERSING VALVE
SUCTION SERVICE VALVE
Fig. 17 - Suction Thermistor (OST) Attachment
(On Suction Tube)
Suction Thermistor (OST)
Suction Thermistor is used for assisting in EXV control and must
be secured on the suction tube and aligned longitudinally to the
vertical surface of the tube axis (see Fig. 17).
CAUTION
!
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
In order to minimize the ambient influence, make sure the
thermistor curved surface hugs the pipe surface and is
secured tight using the wire tie fished through the original
slot insulating polymer body.
Variable Speed Compressor Sensor Output Terminals
This compressor has a motor thermistor and a scroll thermistor.
Correct resistance between scroll thermistor terminal and common
is 10k at 77_F (25_C).
thermistor terminal and common is 5k at 77_F (25_C).
Variable Speed Compressor Power Input Terminals
This compressor operates with a 3- -phase variable frequency PWM
variable voltage to the three fusite terminals.
Table 5 – Variable Speed Compressor Resistances
(winding resistance at 70_F 20_F)
25VNA024
WINDING
25VNA036
Between terminals
T1, T2, and T3
Between terminal &
>1 mega OHM
ground
CAUTION
!
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment damage
and/or improper operation.
Do not use Meggar for measuring the winding resistance.
ACCUMULATOR TUBE
COMPRESSOR
Correct resistance between motor
25VNA048
25VNA060
.681 .203
>1 mega OHM
ECM Fan Motor
If verification of proper operation is required for the ECM motor
used in this unit, follow these steps:
1. Verify that the 230v input to the transformer is present.
2. Verify that the control board is powered 18 volts to 30 volts
from the transformer.
3. With the UI in charging mode in cooling, measure the DC
voltage between the PWM 1 and PWM 2 terminals on the
outdoor control board. The DC voltage and PWM (option-
al) measured must be as shown in Table 6.
Table 6 – DC Voltage and PWM Measurement
Unit Size
024, 036
048, 060
Status Codes
A11103
Table 7 shows the status codes flashed by the amber status light.
Most system problems can be diagnosed by reading the status code
as flashed by the amber status light on the control board.
The codes are flashed by a series of short and long flashes of the
status light. The short flashes indicate the first digit in the status
code, followed by long flashes indicating the second digit of the
error code.
The short flash is 0.25 seconds ON and the long flash is 1.0 second
ON. Time between flashes is 0.25 seconds. Time between short
flash and first long flash is 1.0 second.
repeating is 2.5 seconds with LED OFF.
Codes are easily read from user interface (UI)
EXAMPLE:
3 short flashes followed by 2 long flashes indicates a 32 code.
Table 7 shows this to be low pressure switch open.
Emergency Mode Connections with a Conventional
Dual Fuel Thermostat
In an emergency, it is possible to replace the UI with a
conventional heat pump thermostat (must be dual fuel capable if
using a furnace), see Fig. NO TAG for wiring. However, this
emergency mode operation is limited to a single, maximum
compressor speed in heating and a single maximum cooling speed.
14
Voltage PWM
8.9 VDC 52
11.1 VDC 84
Time between code