Advertisement
Flues With a Flue Draft Stabiliser
When installing with a flue draft stabiliser into houses built before 2008, at least
2
1500mm
additional means of permanent ventilation direct to outside is
required. Houses built after this date will require additional means of permanent
ventilation direct to outside of at least 4250 mm
this.
Top or Rear Flue
ALWAYS OPEN THE STOVE DOOR SLOWLY AND ALWAYS USE THE GLOVE
Primary Air - controllable
Primary air is controlled via the sliding vent in the bottom of the door. This
provides an air draught through the grate to the bed of the fire. Slide right to
open and left to close. Open this when you start a fire, and to regulate solid fuels
other than wood. It should be closed when a wood fire is established for the
best efficiency but can be used to give a wood fire a boost when it is dying out.
Secondary Air - controllable
Secondary air is controlled via the sliding vent above the door, it is this 'airwash'
that keeps a clean and uninterrupted view of the fire, and also aids good
secondary combustion of fuel; thus reducing emissions in the chimney and out
to the environment. Slide to the right to open and to the left to close. Use this
to control wood fires. It should be closed when burning solid fuels other than
wood for the best efficiency after the fire is established.
10
Remove the collar and accessory pack from the stove.
The stove will arrive with the blanking plate fitted to the
rear. This can be removed if required allowing the collar
to be fitted for rear flue installations.
Remove the circular cut out for rear flue installations.
Remember to fit the blanking plate to the unused flue
position if it has been removed.
OPERATION
2
. Gallery Vents can be used for
Advertisement
