How To Use The Remote Control; Front Panel - McIntosh C2500 Owner's Manual

How to use the Remote Control

The supplied HR072 Remote Control is capable of
directly controlling the functions of contemporary
Source Components connected to the C2500 via the
Data Ports.
Note: If at any time the C2500 seems unresponsive to
HR072 Remote Control Commands press the
Push-button first.
Input Source Selection
Press the appropriate Source Push-button to select the
desired program source.
Note: When the C2500 is Off, pressing one of the Source
Push-buttons will switch the C2500 On and it will
go to that Input.
Mute
Press the MUTE Push-button to mute the audio in all
outputs except the REC OUTPUT. The word MUTE
will appear on the Front Panel Information Display.
To un-mute the audio, press the MUTE Push-button
again.
Disc, Server and Recorder Functions
Use these push-buttons to operate a DVD Player, CD
Player, CD Changer, Music Server or Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner sta-
tion presets, tracks on discs or selections on a Music
Server.
Disc and Track
Use the AM (disc) and FM (track) Push-buttons when
a Disc Player or Music Server is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Preset : or Pre-
set 9 Push-button for the next Station Preset. Press
the Seek 7 or Seek 8 Push-button to seek continu-
ously from station to station. To Manually Tune press
and hold a Directional Up p or Down q Push-button
to find available stations.
Volume
Press the Up p or Down q VOLUME Push-button to
raise or lower the listening volume level.
Note: The Record Signals present at REC OUTPUTS are
not affected by volume changes.
Pause
Press the Pause Push-button to perform various
functions on a variety of McIntosh Components. It
will also pause the playing of a disc or tape player.
Trim
Press the TRIM Push-button until the desired Trim
function (Balance, Trim Level, etc.) appears on the
Front Panel Information display, then press the LEV-
EL Up p or Down q Push-button to adjust the Trim
setting.
Note: Press the TRIM Push-button to recall the last Trim
function selected. For additional information on
the Trim Functions refer to pages 20
Amplifier Selection
Press the BLUE (Setup) Push-button followed by the
AM (Output 1) or FM (Output 2) Push-button, to con-
trol the rear panel Audio OUTPUTS 1, 2 (ON or OFF)
and Power Control OUTPUT 1 / OUTPUT 2. These
OUTPUTS provide signals to a Power Amplifier or
other accessory component.
How to use the Remote Control
thru 24
.
11