Before You Begin - Arcam rPLAY Connections And Quickstart Manual

Setup

Before You Begin...

1. When setting up the rPlay using a wireless connection, always wait for the front LEDs to stop flashing after the
unit is switched on. This will allow the rPlay to boot up. The rPlay is ready when the STATUS LED turns red and
the NET LED starts pulsing blue.
2. When setting up the rPlay using a wired connection, always connect the Ethernet cable before the unit is
switched on. Power on the unit and allow the rPlay to boot up. Once a wired connection is established, the
NET LED will turn off and the STATUS LED will turn purple.
Android™ Users
Option 1: My Router Supports Wi-Fi Protected Setup™
1. Press and hold the SETUP button located on the rear panel of your rPlay for approximately 4 seconds. The NET
LED will blink twice at regular intervals.
2. Press the Wi-Fi Protected Setup button
3. The rPlay will now connect to your network and the NET LED will stop blinking and stay on.
4. Download the DTS Play-Fi® app from the Google Play™ store or the Amazon app store.
5. Connect your mobile device to the same network that the rPlay is connected to.
6. Launch the DTS Play-Fi app and follow the on-screen instructions.
Option 2: My Router Does Not Support Wi-Fi Protected Setup
1. Download the DTS Play-Fi app from the Google Play store or the Amazon app store.
2. Launch the app and you will be prompted to set up the new device. Follow the on-screen instructions and
complete the set-up.
3. The rPlay is now set-up and ready for use.
Option 3: Wired Connection To A Network
1. Download the DTS Play-Fi app from the Google Play store or the Amazon app store.
2. Using the supplied Ethernet cable, connect the rPlay to your router.
3. Turn on the rPlay.
4. Connect your mobile device to the same network that you want the rPlay to be connected to.
5. Launch the DTS Play-Fi app and wait for the app to automatically detect the rPlay and connect it to your home
network.
6. The rPlay is now set-up and ready for use.
on your router.
E-5