Advertisement
WIRING:
1. Some vehicles may have an existing hidden rubber grommet or plug available to avoid having to
drill into the body to route the camera cable into the car. If you are going to drill a hole, be sure to
double-check for any wiring or obstructions behind the surface where you are going to drill. Use
silicon or caulking to make a watertight seal for the cable where it passes into the vehicle.
2. Choose a convenient place to run the camera cable up the left, right or center of the vehicle. As
a rule of thumb, try to avoid main factory harness looms that may contain high levels or RF noise
or interference.
3. You can connect the camera power at the rear of the vehicle behind the reverse lights. You may
also connect power inside the vehicle under the dash or in the trunk. The Red power wire goes to
Reverse Light +12V, and the Black wire to Ground.
4. Run the Yellow RCA video cable to your monitor's video input or reverse camera input.
NOTE: There is another small red wire that comes out of the yellow RCA video cable. This wire does
not need to be hooked to anything
Connect to +12V
Reverse Light
RED WIRE
SPECIFICATIONS:
1/4 Inch Color CMOS Sensor
Dimension (In.): ¾"(L) × ¾"(W) × ⅞"(D)
Weight: 7 Oz.
Pixels: 656 (H) x 492 (V)
Resolution: > 250,000 pixels
420 TV lines
Minimum Illumination: 0.5 LUX / F 1.2
Lens Type: Wide Angle
Horizontal Angle: 170°
Vertical Angle: 90°
Ground
BLACK
WIRE
YELLOW RCA
Connect to
Monitor
SV-6703 CAMERA
Video Output: 1.0 V P-P composite (75 Ohm load)
Supply Voltage: +12VDC
Power Consumption: 70mA
Electronic Shutter: 1/50 s – 1/100000s
White Balance: Automatic
Gamma Correction: 0.45
S/N Ratio: More than 48dB
Operating Temp: -22° to 176° F (-30° to 80° C)
Gain Control: Automatic
MONITOR
TECH SUPPORT:
800-998-6880
Advertisement
