Details Of Electrical Adjustment - Panasonic DMC-FX77EB Service Manual

9.3.

Details of Electrical Adjustment

9.3.1. How to execute the Electrical Adjustment
It is not necessary to connect the camera to a PC to perform adjustments.
"Flag reset operation" and "Initial setting operation" are required when carrying out the alignment, follow the procedure below.
9.3.1.1. Startup Electrical Adjustment mode
1. Release the initial settings.
2. Insert a recordable SD card.
(Without a SD card, the automatic adjustment can not
executed.)
3. Procedure to set the camera into adjustment mode:
a. Turn the Power on.
b. Select with the touch panel in order to [ REC ] mode
and [ NORMAL PICTURE ] mode.
c. Turn the Power off.
d. Touch the screen while the power is turned on.
LCD monitor displays "SERVICE MODE" (Fig. 3-1),
and then start the automaticcaly adjustment software.
9.3.1.2. Status Adjustment Flag Setting
Reset (Not yet adjusted) the status flag condition.
1. Move the [ ZOOM LEVER ] to "W" side.
2. While display the screen, select the "T" or "W" side of
[ ZOOM LEVER ] to adjustment item (Flagged items), and
then press the [ SHUTTER BUTTON ].
NOTE:
The selected item's flag has been changed from
"F (green)" to "0 (yellow)".
*Flag conditions:
F (green)
means that the alignment has been completed and the
status flag condition is set. In this case, the flag condition
should be reset, if you try to carry out the automatic align-
ment.
0 (yellow)
means that the alignment has been not "completed" and
the status flag condition is "reset". In this case, automatic
alignment is available.
• In case of setting the status flag into set condition again without completion of the alignment, the status flag should be SET by
using PC, or UNDO by using ROM BACKUP function.
40