JVC Kd_X340BTS Instruction Manual page 36

TROUBLESHOOTING
Symptom
"CH LOCKED LOCK CODE?"
"CHAN UNSUB"
"CH UNAVAIL"
"CHECK ANTENNA"
"CHECK TUNER"
"NO SIGNAL"
"SUBSCRIPTION UPDATED
– PRESS ENTER TO
CONTINUE."
"CODE ERROR"
"NO CONTENT"
"SCAN CANCEL"
No Bluetooth device is
detected.
Pairing cannot be made.
Echo or noise occurs.
32
ENGLISH
JS_JVC_KD_X340BTS_K_EN_3.indd 32
Remedy
The selected channel is locked. Enter the correct pass code
to unlock. ( 13)
The selected channel is unsubscribed.
Call 1-866-635-2349 in the U.S.A. or 1-877-438-9677 in
Canada to subscribe.
The selected channel is unavailable. For more
information about the SiriusXM channel lineup, visit
<www.siriusxm.com>.
Check that the antenna and its connection are in good
condition.
Make sure the SiriusXM Vehicle Tuner is connected to the
unit.
Make sure the antenna is mounted outside the vehicle.
Your subscription is updated. Press the volume knob to
continue.
Make sure you have entered the correct pass code. ( 13)
There is insufficient content to start TuneScan.
TuneScan has been aborted.
• Search from the Bluetooth device again.
• Reset the unit. ( 3)
• Make sure you have entered the same PIN code to both
the unit and Bluetooth device.
• Delete pairing information from both the unit and the
Bluetooth device, then perform pairing again. ( 14)
• Adjust the microphone unit's position. ( 14)
• Check the [ECHO CANCEL] setting. ( 16)
Symptom Remedy
Phone sound quality • Reduce the distance between the unit and the Bluetooth
is poor device.
• Move the car to a place where you can get a better signal
reception.
Sound is being interrupted • Reduce the distance between the unit and the Bluetooth
or skipped during playback audio player.
of a Bluetooth audio • Turn off, then turn on the unit and try to connect again.
player. • Other Bluetooth devices might be trying to connect to
the unit.
The connected Bluetooth • Check whether the connected Bluetooth audio player
audio player cannot be supports Audio/Video Remote Control Profile (AVRCP).
controlled. (Refer to the instructions of your audio player.)
• Disconnect and connect the Bluetooth player again.
"PLEASE WAIT" The unit is preparing to use the Bluetooth function. If the
message does not disappear, turn off and turn on the
unit, then connect the device again.
"NOT SUPPORT" The connected phone does not support Voice Recognition
feature.
"ERROR" Try the operation again. If "ERROR" appears again, check
if the device supports the function you have tried.
"H/W ERROR" Reset the unit and try the operation again. If "H/W
ERROR" appears again, consult your nearest service
center.
If you have any troubles, try the following:
1 Check TROUBLESHOOTING
2
Reset the unit ( 3)
3
Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: <http://www.jvc.com>
9/8/2016 10:36:07 AM