KBE-271-4140K_Instructions.qxd
01/02/2011
KOBE
SPECIFICATIONS
I N D U S T R I A L
POWER TOOLS
MODEL NUMBER: ................................................................................................................. SBD370
MOTOR (Induction): .......................................................................................... 230V AC, 50Hz, 370W
MOTOR SPEED (No load): ................................................................................................... 2850RPM
DISC SIZE (Diameter): ........................................................................................................... 150mm
DISC TYPE: .............................................................................. PSA type (Pressure sensitive adhesive)
BELT SIZE: ...................................................................................................................100 x 914mm
BELT SPEED: .................................................................................................. 580m/min (1900 SFM)
BELT TILT: .............................................................................................................................. 0 - 90°
WORK TABLE TILT: .................................................................................................................. 0 - 45°
SOUND PRESSURE (LPA): ..................................................................................................... 79.9dBA
SOUND POWER (LWA): ......................................................................................................... 91.1dBA
NET DIMENSIONS: .............................................. 285 - 620 (H) with belt vertical x 450(W) x 365(D)mm
NET WEIGHT: ......................................................................................................................... 18.6kg
Supplied with: 1 x 150mm P80 sanding disc
1 x 100 x 914mm A80 sanding belt
KOBE
IDENTIFICATION
I N D U S T R I A L
POWER TOOLS
COMPONENTS
Drive belt
cover
Drive drum
Belt tensioning
lever
Dust port
(not visible)
see
Fig.4c
Table adjuster
(not visible)
see
Fig.4b
Mitring
attachment
Sanding
table
4
09:52
Page 4
Sanding
stop
Belt tracking
adjustment knob
Belt sanding
area
Fig. 1
Disc
NO VOLT
sanding area
On/Off switch
KOBE
CHANGING CONSUMABLES
I N D U S T R I A L
POWER TOOLS
SANDING DISC
Follow steps 1 to 8, Figs.10-16
1. Remove the mitre gauge, work table & disc guard.
2. Remove the self adhesive sanding disc from the plate.
3. Clean off any adhesive remaining on the plate with a
suitable cleaning spirit.
4. Spread your thumb and middle finger on the edge of
the plate as a guide for placing the disc.
5. Carefully align the edge of the disc with the edge of the
plate before pressing it firmly in place.
6. Refit the disc guard
7. Refit the Work table, making sure the gap between the
table and disc is no more than 1.6mm when horizontal.
8. Replace the mitre gauge.
Fig. 11
Fig. 13
Idler drum
Fig. 15
Base
fixing
flange
Note: Hook and loop sanding discs cannot be used with this machine.
Fig. 12
Fig. 14
Fig. 16
Fig. 10
9