Table of Contents
Advertisement
10. ENGINEERING MODE
10.2 RF Test [MENU 2]
10.2.1 SAR test
This menu is to test the Specific Absorption Rate.
1) SAR test on : Phone continuously process TX only. Call-setup equipment is not required.
2) SAR test off : TX process off
10.3 MF mode [MENU 3]
This manufacturing mode is designed to do the baseband test automatically. Selecting this menu will process
the test automatically, and phone displays the previous menu after completing the test.
10.3.1 All auto test
LCD, Backlight, Vibrator, Buzzer, Key Pad, Mic&Speaker,
10.3.2 Backlight
LCD Backlight is on for about 1.5 seconds at the same time, then off.
10.3.3 Buzzer
This menu is to test the volume of Melody. It rings in the following sequence. Volume 1,
Volume 2, Volume 3, Volume 0 (mute), Volume 4, Volume 5.
10.3.4 Vibrator
Vibrator is on for about 1.5 seconds.
10.3.5 LCD
1)LCD
Main LCD screen resolution tests horizontally and vertically one by one and fills the screen.
10.3.6 Key pad
When a pop-up message shows 'Press Any Key', you may press any keys including side
keys, but not [Soft2 Key]. If the key is working properly, name of the key is displayed on
the screen. Test will be completed in 15 seconds automatically.
LGE Internal Use Only
LGE Internal Use Only
Copyright © 2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
- 134 -
Copyright © 2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Advertisement
Table of Contents
