Advertisement
1
^
%
$
#
@
!
)
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING:
stances should you try to repair the set yourself, as this will invalidate the warranty.
1
2
No sound
3
– Volume not adjusted
• Adjust the VOLUME 3, 4
4
5
Button fail to react
– Electrostatic discharge
6
• Press the RESET hole, or disconnect the set from
7
the power supply, and reconnect the set after 5
8
minutes.
9
indication
0
– No disc inserted
• Insert a suitable disc
– CD badly scratched or dirty
• Replace/ clean CD
– Laser lens steamed up
• Wait until lens has adjusted to room temperature
– Laser lens dirty
&
• Clean lens by playing a CD lens cleaning disc
– CD-R/CD-RW is non-finalized
• Use a finalized CD-R/CD-RW
Note:
Make sure the CD is not encoded with
Copyright protection technologies, as some
do not conform to the Compact Disc
*
standard.
Environmental information
All unnecessary packaging material has been omitted.The packaging can be easily separated
into three materials: cardboard, polystyrene and plastic.
(
Your set consists of materials which can be recycled if disassembled by a
specialized company. Please observe the local regulations regarding the
disposal of packaging, dead batteries and old equipment.
Do not open the set as there is a risk of electric shock. Under no circum-
The CD skips tracks
– CD damaged or dirty
• Replace or clean CD
– PROG is active
• Quit PROG mode
Occasional crackling sound during FM
broadcast
– Weak signal
• Extend FM antenna fully
Continuous crackling/ hiss disturbance
during MW broadcast
– Electrical interference from TVs, computers,
fluorescent lamps, etc.
• Move set away from other electrical equipment
The alarm does not function
– CD or radio switched on
y
• Press
– Alarm time not set
• See Setting the alarm time
to switch off the set.
Advertisement
