Table of Contents
Advertisement
Important notes for users in the U.K.
Mains plug
This apparatus is fitted with an approved 13 Amp plug.To change a fuse in this type of
plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be cut off and an
appropriate plug fitted in its place. If the mains plug contains a fuse, this should have a
value of 3 Amp. If a plug without a fuse is used, the fuse at the distribution board
should not be greater than 3 Amp.
Note:The severed plug must be disposed of to avoid a possible shock hazard should it
be inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following code: blue = neutral (N),
brown = live (L). As these colours may not correspond with the colour markings
identifying the terminals in your plug, proceed as follows:
•
Connect the blue wire to the terminal marked N or coloured black.
•
Connect the brown wire to the terminal marked L or coloured red.
•
Do not connect either wire to the earth terminal in the plug, marked E (or e) or
coloured green (or green and yellow).
Before replacing the plug cover, make certain that the cord grip is clamped over the
sheath of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may require consent. See Copyright Act 1956 and
The Performer's Protection Acts 1958 to 1972.
Environmental information
All necessary packing material has been omitted to make the packing easy to separate
into 2 categones: cardboard and paper pulp.
Your unit consists of materials which can be recycled if disassembled by a specialized
company. Please observe local regulations on the disposal of packing materials and
old equipment.
Advertisement
Table of Contents
