Table of Contents
Advertisement
Main room slideout override
If
the
RV
has
underbelly,
locate
remove the access panel
to access the slideout
motor
(this
panel
typically under the RV on
the opposite side of the
slideout room). Use a 3/4
socket and ratchet on the
hex head located on the
end of the drive shaft. Turn the drive shaft until
the slideout is in the position you desire.
Contact your RV dealer for service.
Tools required
ScruLox head screwdriver (if RV has an
underbelly)
Adjustable wrench or ratchet and 3/4
socket.
Bedroom slideout override
Access
the
slideout
motor located under the
bed
platform.
Disconnect
one
slideout
motor
wire
near the motor. Using a
5/8"
wrench
(or
socket/ratchet
combination) rotate the
motor
shaft
counter
clockwise to retract the
bedroom
slideout
room. Once the room is fully extended (or
retracted), apply pressure to the wrench to
fully set the room. The worm gear in the
gearbox will prevent the room from drifting in or
out. Contact your RV dealer for service.
Tools required
ScruLox head screwdriver
5/8" wrench (or ratchet and 5/8" socket).
For more information
If you have further questions please refer to
the applicable OEM operator's manual,
contact your RV dealer or Jayco Customer
Service.
an
and
is
Fig. 8.7 Main
slide hex head
Motor
Shaft
Fig. 8.8 Bedroom
slide motor
CAMPING & OPERATING
H
-A-B
(I
S
IDE
ED
F
The hide-a-bed sofa functions much the same
as a regular residential hide-a-bed sofa. To
make the hide-a-bed sofa into a bed, remove
the seat cushions and pull the strap located at
the front of the sofa seat bottom out towards
you firmly and gently. To convert the
hide-a-bed back into the upright sofa position,
reverse the process (make sure to pull the seat
belts out into their usable positions). Be sure to
hold the sofa strap firmly to ensure the
hide-a-bed sofa does not suddenly drop shut.
Refer to the furniture manufacturer's care
instructions for this product.
C
/J-S
D
OUCH
TEEL
(I
S
E
)
F
O
QUIPPED
Fig. 8.2 Couch/J-steel dinette
1. Release
the
couch/dinette in place against the wall.
2. Pull down on the metal support bar under
the couch/dinette. The legs will fold out
and into place. When pulled out from the
wall, the unit will be in the bed position.
3. To set up as a couch/dinette, stand at the
end of the couch/dinette seat. Pull up on
the top of the back rest and the front edge
of the seat to create a V-shape. Push the
seat toward the back rest to move the unit
into the set up position.
SECTION 8
E
)
O
QUIPPED
INETTE
buckle
holding
the
73
Advertisement
Table of Contents
