Table of Contents
Advertisement
dealer or Jayco Customer Service. The rear
ramp label should be kept permanently affixed
to your RV
S
R
LIDEOUT
OOM
(I
S
E
)
F
O
QUIPPED
WARNING
Ensure that the trailer is level before
operating the slideout room. Water leaks
and other problems could result if the
slideout is operated without leveling the
trailer.
Ensure there are no people or obstructions
blocking the path of the room when it is
moving. Keep away from the slide rails
when the room is in motion. The gear
assembly may pinch or catch on loose
clothing causing personal injury.
Ensure the slideout is in the closed position
prior to hooking the unit to the tow vehicle.
FAILURE
TO
INSTRUCTIONS COULD RESULT IN
SERIOUS INJURY OR DEATH.
CAUTION
Do not place excessive weight in the
slideout room. It can cause the slideout
room to malfunction and cause damage to
the slideout.
The slideout room system is designed for
additional floor space and comfort. The
mechanical components are gear driven.
Electric powered slideout room systems have
a manual override to allow you to extend or
retract the slideout room(s) in case of a power
loss.
For the slideout system to work properly, the
RV must be leveled before extending the
room. Periodically check the accuracy of the
leveling system. Check the vehicle leveling
S
YSTEM
FOLLOW
THESE
CAMPING & OPERATING
system by placing a circular bubble level in the
center of the freezer floor with the RV leveled.
Make sure you have sufficient power available
before operating your slideout system (refer to
Sec. 2 Electrical Systems, Calculating
electrical load).
Major components
One inner rail drive assembly to support
the room weight.
A 12-volt DC motor and drive shaft
operates the room using energy from
on-board auxiliary batteries (customer
supplied).
A specially designed auto reset breaker
with load sensing capability to stop the
motor when the room reaches its fully
extended or retracted position.
Extending the slideout room
1. The auxiliary batteries (customer supplied)
must be fully charged and connected. If
possible, the RV should be hooked up to
120-volt AC power so that the converter
operates.
2. The RV must be level and the stabilizer
jacks in the extended position.
CAUTION
Additional support jacks are not needed
under the slideout. Damage can occur to
your slideout room from improper use of
aftermarket support jacks.
3. Locate the slideout room
control switch. The main
slideout
switch
equipped) is located in the
command center.
bedroom slideout switch (if
so equipped) is located on
an bedroom interior wall.
4. To move the room out,
press the OUT section of
the switch and hold it until
the motor stops (travel
time
is
approx.
seconds). Operating the
SECTION 8
(if
so
The
Fig. 8.5
Bedroom
slideout
control
switch
25
71
Advertisement
Table of Contents
