Table of Contents
Advertisement
The BASIC Home page displays.
4.
Select ADVANCED > Setup > LAN Setup.
Your modem router might display information that is different from this example.
5.
In the IP Address field, type the IP address.
6.
In the IP Subnet Mask, type the subnet mask of the modem router.
The IP address and subnet mask identify which addresses are local to a specific device and which must
be reached through a gateway or modem router.
7.
Change the RIP settings.
Router Information Protocol (RIP) allows a router to exchange routing information with other routers.
a.
Select the RIP direction:
•
Both. The router broadcasts its routing table periodically and incorporates information that it
receives.
•
Out Only. The router broadcasts its routing table periodically.
•
In Only. The router incorporates the RIP information that it receives.
b.
Select the RIP version:
•
Disabled. This is the default setting.
•
RIP-1. This format is universally supported. It is adequate for most networks, unless you are
using an unusual network setup.
•
RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the routing data in
RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses multicasting.
8.
Click the Apply button.
Your settings are saved.
Nighthawk AC1900 WiFi LTE Modem Router
Network Settings
62
Advertisement
Table of Contents
