Display Elements; Using The Appliance - Bosch Filtrino THD20 series Instruction Manual

16
temp. set button
Press the temp. set button to cycle through
and select one of the temperature settings.
The selected temperature lights up.

Display elements

On this setting, ambient water will
L
be supplied.
With the 70 °C, 80 °C and 90 °C
settings, the water will be heated to
the selected temperature.
Examples
70 °C – for white tea
70 °C
80 °C 80 °C – for green tea
90 °C – for instant beverages such
90 °C
as hot chocolate or coffee
Note: The temperatures at the
water outlet can vary by approxi-
mately ± 5 %.
At this setting, the water will be
boiled. This setting is suitable, for
Q
example, for black tea or instant
soups.
When the M icon lights up, the
B RITA M AXTRA filter cartridge
should be replaced. You can
continue to heat water. For informa-
tion about replacing the water
M
filter cartridge, see the section
titled " B RITA M AXTRA water filter
system".
After changing the filter, hold down
the start/stop button for at least
2 seconds, M will cease to light.
The O icon lights up when the
water tank needs to be refilled or is
O
missing. Remove the water tank, fill
it with fresh, cold water and return it
to its correct position.
The N icon lights up when the
appliance needs to be descaled.
N
Always follow the instructions in the
"Descale" section when you descale
the appliance.
Robert Bosch Hausgeräte GmbH
The P icon lights up when the child
lock is activated. At this point the
water heater is deactivated, but you
P
can still draw ambient water. To
learn more about this setting, read
the section titled "Child lock".
M and N flash at the same time
M
if there has been no hot water
drawn for some time. For hygienic
+
N
reasons, set the temperature to
90°C or Q and draw hot water (1 x).
Extinguish M and N ; the tempera-
ture last set lights up.

Using the appliance

General
With this appliance, you can filter water and
dispense it at room temperature or heated
to specific temperatures.
If you have questions regarding the filter
cartridge, contact the B RITA Consumer
Service at 0844 742 4800 (toll-free).
Note: The appliance is checked before
delivery, which means there may be some
isolated drops of water found. These drops
of water are harmless, simply remove with
a cloth.
Setting up the appliance
Before you use the appliance for the first
time, do the following:
Remove film.
►
Unroll or push in the right amount of
►
cable from the cable compartment and
plug the cable into a power outlet.
Remove the water tank and clean it
►
thoroughly under running water.
Insert the filter cartridge as described in
►
the section titled " BRITA MAXTRA water
filter system".
Fill the water tank up to the max mark
►
with fresh, cold water. Use only non-
carbonated drinking water.
Replace the water tank and push it firmly
►
downward into place.
en