Operating Control Instruction - ROHS LED-PAR64-3W90BL-RGBW User Manual

 Pr28:four colors jumping change.

9. Operating Control Instruction


Master/Slave
Master：The master should always working as a master as long as it is not set in a DMX
mode whatever other modes it is. And it send out the signal so that the slave synchronous
with it. To avoid the host signal and DMX512 signals interfere with each other, should cut off
the DMX512 signals. The signal lines are longer than 60 meters(20 lamps) ,should increase
a signal amplifier.
Slave：he Slave must be set in DMX mode and the address code should be A001, to
assure receive the master's signals correctly. Only one light can be set as a Master and
others are slaves.
Note: This product uses input and output power cord 2.5 m ㎡ copper core wire,
power line in series, when 220V AC should less than 10lights, and 110V AC less than 5
lights! ! !
 XRL cable：
The stand connection way of the XRL is: one end connect to the male plug ,and the
other connect to the female.
10. XLR cable connecting
9