Turn Tamper Check On Or Off; Check For Tampering - National Vendors shoppertron 431 Operator's Manual

Shoppertron

TURN TAMPER CHECK ON OR OFF

If a vend door has been moved and there is still a product in that location it is con-
sidered to have been tampered with, and should not be sold. Proper operation of
this feature assumes that you have configured the machine so that the actual
number of compartments per tray agrees with the quantity you entered in "Set
Number of Compartments" on page 28.
1. Press
T A M P E R O F F - The tamper check feature is inoperative.
T A M P E R O N - The tamper check feature is operating.
2. Press
3. CONTINUE.

CHECK FOR TAMPERING

The following example shows you how to perform a tamper check on a machine
which is configured to have 3 compartments per tray on all 9 levels. Our example
machine has a total of 24 out of 27 possible items visible in the half-zone behind
the delivery doors.
1. Press
This means that the tamper check feature is on and the machine thinks there are
23 items remaining behind the doors (the - 1 shows that the right half of zone 1 is
behind the doors). Remember that with 3 compartments per level, there is a
maximum of 27 items that can be present behind the doors. Therefore, there
is one item that is considered sold but is still present.
Next, look at the price displays. Each price display shows whether one or more
of the products at that level has been sold. On level 1, the price display shows 1 2
3 . This means that all three compartments on level 1 should be full. You count
the products on level 1, and they are all there. On level 2, the price display shows
1 3 . This means that the middle compartment should be empty, but it has a prod-
uct in it. This product has been tampered with and should be removed.
After the product is removed, the number of full compartments agrees with the
number 23 in the display. At this point, you can leave the function,
2. Add products to the four empty compartments, then press and hold
The display shows C L E A R I N G , then F I N I S H E D . You have now indicated that all
the compartments in the machine have products.
3. Repeat steps above until all half-zones in the machine have been checked.
4. CONTINUE.
4310114
Operator's Guide
TM
. Press until the display shows one of the following:
to switch between tamper check on and off.
. Press until the display shows - 1 Q T Y 2 3
Page 33
- OR -
- OR -
.
.
July, 2003