Shuffle (Random Order) Play; Repeat Cd, Track Or Program; Programming; Remarks About Programming - Philips CDR570/00 Instructions For Use Manual

PLAYING

Shuffle (random order) play

1 Press SHUFFLE on the remote control before or during CD
play to start shuffle play.
The tracks on the CD (or program if set) play in random
order.
2 Press SHUFFLE on the remote control again to return to
normal CD play.
Note: Shuffle is also cleared if you open the disc tray.

Repeat CD, track or program

1 Press REPEAT on the remote control one or more times
during CD play.
When lights up, the current track plays
REPEAT TRACK
repeatedly. When
REPEAT ALL
program plays repeatedly.
REM REC TIME TRACK TOTAL
1 2 3 4 5 6 7 8
DIGITAL I
PROGRAM
OPTICAL I
CD
RW
ANALOG
2 To return to normal play, press REPEAT on the remote
control one or more times until:
The label disappears from the display.
REPEAT
Note:
- You can use shuffle in combination with
programmed play.
- is also cleared if you open the disc tray.
REPEAT
lights up, the disc or
REM TRACK TIME FADE STEP
SYNC
MANUAL SCAN
SHUFFLE REPEAT TRACK ALL
or
REPEAT ALL

Remarks about programming

• You can program up to 99 tracks to play in any desired
sequence.
• Tracks can be programmed more than once, but each time
counts as a track ( ).
STEP

Programming

1 In Stop mode press PROG(ram) on the remote control to
enter Program mode.
flashes and PROGRAM appears on the display.
PROGRAM
REM REC TIME TRACK TOTAL
1 2 3 4 5 6 7 8 9 10 11
DIGITAL I
PROGRAM
OPTICAL I
CD RW
ANALOG
2 Select the required track numbers by turning the EASY
JOG/ENTER key left or right and store by pressing ENTER.
REM TOTAL
REC TIME TRACK
2 7 8 11
DIGITAL I
PROGRAM
OPTICAL I
CD
RW
ANALOG
or:
Key in a track number with the number keys. For 2-digit
numbers, press the keys in rapid succession.
The track will be stored in the program.
The track number, total program time and the number of
programmed tracks (
STEPS
3 Repeat step 2 for all tracks to be programmed.
4 Press STOP or PROG(ram) on the remote control to end
programming.
lights continuously.
PROGRAM
5 Press PLAY/PAUSE 2 ; to start programmed play.
Note:
- To review the program, press PROG(ram) on the remote
control, followed by 5 or 6 with the CD recorder in Stop
mode.
- To add more tracks to the program, repeat steps 1 to 5.
- If you try to store more than 99 tracks, PROG FULL
appears on the display.
PROGRAMMING
REM TRACK TIME FADE STEP
MANUAL SYNC SCAN
SHUFFLE REPEAT TRACK ALL
REM FADE
TRACK TIME STEP
MANUAL SYNC SCAN
SHUFFLE REPEAT TRACK ALL
) are displayed.
21