Driving Data (Multifunction Display) - Skoda A7 Octavia Owner's Manual

Skip to next track/station

Switch to previous track/station

Display the assistance systems menu

Press - display the telephone menu; accept/end the call; select contact

Hold - repeat last call; reject call
Operating the multifunction display
Turn - select data / set values
B
Press - display / confirm data
Operating the MAXI DOT display
Hold - display main menu

Press - return to a higher level in the menu
Turn - move in the selected menu
B
Press - confirm selected menu item
Note
Depending on equipment not all functions may be available. The system indi-
cates this by means of a text message on the Infotainment screen.

Driving data (Multifunction display)


Introduction
The driving data display is only possible with the ignition switched on. After
the ignition is switched on, the function that was last selected before switch-
ing off the ignition is displayed.
If vehicles with MAXI DOTdisplay do not show the journey data after switch-
ing on the ignition, select the menu item Journey data in the main menu and con-
firm » page 47.
The units can be set and some information can be displayed in Infotainment in
the menu /  →  → Units.

Note
The setting of the information display is stored in the active user account per-
sonalisation » page 50.
Information Overview
Overview of driving data (depending on the vehicle equipment).
Range - drive distance in km which can be covered with the existing tank ca-
pacity and with the same driving style. If you drive more efficiently this value
can increase. With G-TEC vehicles the following details are displayed - total
range / with natural gas / petrol.
Average fuel consumption - is calculated continuously since the last time the
memory was deleted. After erasing the memory, no data will appear for the
first 100 m driven. With G-TEC vehicles, the average consumption of fuel cur-
rently being used is displayed.
Current fuel consumption - when the vehicle is stationary or slowly moving,
the fuel consumption is displayed in l/h (--,- km/l appears on models for some
countries). With G-TEC vehicles the current consumption of the fuel currently
being used is displayed ( with regards to a stationary or slow moving vehicle,
the natural gas consumption is displayed in kg/h).
Oil temperature - if the temperature is lower than 50 °C or if there is a fault in
the system for checking the oil temperature, the  symbols are displayed.
Warning when the preset speed is exceeded - allows the setting of a speed
limit where, if exceeded, an acoustic warning signal and a warning message ap-
pears on the display of the instrument cluster.
Traffic sign recognition - traffic signs display
nition.
Current speed - digital speedometer.
Average speed - is calculated continuously since the last time the memory
was deleted. After erasing the memory, no data will appear for the first 300 m
driven.
Driving route - distance driven since the last time the memory was deleted.
Driving time - driving time since the last time the memory was deleted.
Comfort consumers - information about the total consumption of the com-
fort consumers in l/h and a list of three consumers (e.g. air conditioning etc.),
which have the largest share of fuel consumption.
» page 246, Traffic sign recog-
45
Information system
