Page 1
Periodically wipe the case with a dry cloth. Do not use abrasives or solvents on this instruments. Safety symbols Meter is protected throughout by double insulation or reinforced insulation. When servicing, use only specified replacement parts. Comply with EMC TES ELECTRICAL ELECTRONIC CORP.
2. SPECIFICATIONS Basic Accuracy: ( @23± 5℃ Calibration ) Accuracy are± ( ...% of 2-1 Electrical Specifications reading + degree ) at 18℃ to 28℃ with relative humidity up to 80% Measurement Range : Type J : Type K : For single thermocouple measurements -200℃...
the operating voltage. ( 32℉ to 64℉ and 82℉ to 104℉ ) Power Requirement: For each ℃ ( ℉ ) ambient below 18℃ ( 64℉ ) or above 28℃ 9-Volt battery , NEDA 1604 or JIS 006P or IEC6F22 ( 82℉ ), add to the accuracy specifications: Battery Life (typical): 100hours ( Alkaline Battery ) 0.01%...
If hold this key 2 seconds the meter will be back to the normal “MIN” "T1" , "T2" , "T1-T2" , "℃" , "℉" ,low battery " " etc. mode. 2). ON/OFF: The on/off key will turn the thermometer on and off. 8).
5. OPTIONAL ACCESSORY TP-K02: Available for temperature measurement of liquid, gels or air. K ( CA ) type thermocouple. Model Range Tolerances Description with Teflon tape insulation. ±2.2℃or±0.75% -50℃ to 200℃ TP-K01 Maximum insulating Bead probe (±3.6℉ or ±0.75%) -58℉ to 392℉ temperature : 260℃...
Page 7
TES ELECTRICAL ELECTRONIC CORP. 7F, No. 31, Lane 513, Rui Guang Road, Neihu Dist. Taipei. Taiwan, R. O. C. Tel : (02) 2799-3660 Fax : 886-2-2799-5099 E-Mail : tes@ms9.hinet.net http://www.tes.com.tw June-2000-4...