TES -1307 Instruction Manual

Datalogging k/j thermometer

Advertisement

Quick Links

Datalogging K/J Thermometer
TES-1307
INSTRUCTION MANUAL
TES ELECTRICAL ELECTRONIC CORP.

1. SAFETY INFORMATION

Read the following safety information carefully before attempting to
operate or service the meter.
Use the meter only as specified in this manual; otherwise, the protection
provided by the meter may be impaired.
Environment conditions
 Altitude up to 2000 meters
 Relatively humidity 80% max.
 Operation Ambient 0~40℃
Safety symbols
When servicing, use only specified replacement parts.
Caution refer to this manual before using the meter.
Dangerous voltages.
Meter is protected throughout by double insulation
or reinforced insulation.
Comply with EMC
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TES-1307 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for TES TES-1307

  • Page 1  Operation Ambient 0~40℃ Safety symbols When servicing, use only specified replacement parts. Caution refer to this manual before using the meter. Dangerous voltages. Meter is protected throughout by double insulation or reinforced insulation. Comply with EMC TES ELECTRICAL ELECTRONIC CORP.
  • Page 2 2-2 Electrical Specifications 2. SPECIFICATIONS Basic Accuracy: ( @23± 5℃ Calibration ) Accuracy are± ( ...% of 2-1 General Information reading + degree ) at 18℃ to 28℃ with relative humidity up to 80%. Display : Dual display LCD. For single thermocouple measurements Measurement Range : Type K :-190℃...
  • Page 3 3. FRONT PANEL DESCRIPTION b). Press the button again the LCD will show “ ”. The LCD display will show the minimum temperature measurement together with the time that had been recorded since the meter last reset. c). Press the button again, the LCD will show “ ”...
  • Page 4  If we press it again, the meter main display will show T1-T2, and the 5. OPERATION INSTRUCTIONS secondary display will show T1, T2, in circulation. (7). REC/ERASE : (1). Plug the temperature probe into T1 or T2 input connectors. Data recording / reset datalogger (2).
  • Page 5 (3). Stop recording :  Press (clock) button enter year.  Press the button again to  Press button for increasing the value of parameters, increasing the ERASE stop recording. parameter rapid.  Press button for moving to the desired parameter. (4).
  • Page 6 TP-K01: Available for general condition, especially for complex Then pls press (INTV) button to save the set value. While in the ERASE and any place hard to reach. set mode, if users intend to escape from the mode and don’t want to save the value, users can press HOLD to end it.
  • Page 7  RS-232 protocol : are enclosed within the content of CD-ROM, please open the CD-ROM for details. TES ELECTRICAL ELECTRONIC CORP. 7F, No. 31, Lane 513, Rui Guang Road, Neihu Dist. Taipei. Taiwan, R. O. C.

Table of Contents