Filling Water; Dispensing Water - Hisense RQ560N4WC1 User Operating Manual

Assembling
After cleaning, please assemble the parts
including the head, water tank and lids as
follows:
1. Put the seal ring in order first ( the seal
ring can not turn up), then insert the head
into the hole.
2. Hold the two sides of the water
tightly, fit the water tank along the guids
on the door.
3. Push the two sides of the water tank
downward as the picture shows.
4. When you hear clicks by both sides and
at the same time the both sides of the water
tank is closed to the door liner, It means the
installation is completed.

Filling water

Before you fill the drinking water into the
water tank, ensure that the water tank is
steady and in a correct position.
guide
head
slot
tank
seal ring
Caution!
Fill with water up to 3.5L ( which is
suggested) and not above the level.
Otherwise, it may overflow when the lids
is closed.
We recommend that you fill the water by
the following ways.
1.Remove the small lid and fill water from
the inlet of the larger lid.
2.Remove the cover of the rank, and then
fill water inside directly.
Warning!
Don't touch the
appliance when filling water, it may
cause the water leakage.

Dispensing water

1.Make sure the cover of the water tank
is fitted on.
2.Close the fridge door and check the
dispenser.
Before you dispense the water, make
sure the lock device is on the "Unlock"
situation.
Warning!
The lock is defined as "child lock".
Don't push the dispenser lever forward
strongly, when the dispenser is on "Lock"
14
other parts of the