Model 280B
G. The record signal at the output of the record
amplifier, or the recorded signal at the output
of the playback head, may be monitored while
the recording is being made. (Monitor switch
in RECORD or PLAYBACK position).
H. To change the channels which are recording,
move the desired channel Function Selector
Switch to RECORD READY.
3.7
SYNC MODE (Multi-channel Units only)
While recording on one channel, playback of an
other previously recorded channel may be obtain
ed from the recording head stack. This is accomp
lished by setting the Function switch on the
appropriate record/playback control panel to the
SYNC position.
Figure 3-2. Tape Threading Path
Operation
3.8 EDIT MODE
The Edit mode can only be entered from (or dis
abled by) the Stop mode. To edit the tape:
A. Set the Function switch to SAFE and the
Monitor switch to PLAYBACK.
B. With the transport in the Stop mode, press
the EDIT pushbutton. This spills and plays
back the tape until the STOP pushbutton is
pressed.
IEEI
Hold the loose tape away from the capstan.
C. Press the STOP pushbutton when the edit
point is reached.
3-3/3-4