Download  Print this page

Radio Reception - Philips AQ5130 User Manual

Stereo radio cassette recorder.
Hide thumbs
   

Advertisement

Power Supply
Using AC power
1 Check if the power voltage, as shown on
the type plate located on the
bottom of the set, corresponds to your
local power supply. If it does not, consult your
dealer or service center.
2 If your set is equipped with a voltage
selector, adjust the selector so that it
matches with the local mains.
3 Connect the power cord to the AC INPUT
inlet and the wall socket.The power cord is
now connected and ready for use.
4 To switch the set off completely, withdraw the
power cord from the wall socket.
Disconnect the power cord from the wall
socket to protect your set during heavy
thunderstorms.
Helpful hints : To avoid unnecessary energy
consumption, always adjust the Source
selector to TAPE after using the set. Also
check that the tape deck keys are released.
The type plate is located on the bottom
of the set.
CAUTION
Use of controls or adjustments or
performance of procedures other than
herein may result in hazardous radiation
exposure or other unsafe operation.
General Operation/ Radio
General operation
Switching on and off and selecting
functions
1 To switch on, push the Source selector
slider to TAPE or RADIO as desired.
2 To switch off, push the Source selector
to TAPE and check the cassette keys are
released.
Helpful hints:
– To change from TAPE to RADIO , or when
you are switching off the set: first, make sure you
press the STOP•EJECT 9/ key to end
playback and all the cassette keys are released.
Adjusting volume
Adjust the volume with the VOLUME
control.

Radio reception

1 Adjust the source selector to RADIO.
2 Adjust the band selector to select your
desired waveband, MW or FM.
3 Turn TUNING to tune to a station.
- FM STEREO lights up for stereo FM
reception.
4 To switch off the radio, adjust the source
selector to TAPE position.
To improve radio reception:
For FM, extend and turn the telescopic
antenna for best reception. Reduce its
length if the signal is too strong.
For MW, the set uses a built-in antenna.
Direct this antenna for best reception by
turning the whole set.

Advertisement

Table of Contents

   Also See for Philips AQ5130

   Related Manuals for Philips AQ5130

This manual is also suitable for:

Aq5130/98

Comments to this Manuals

Symbols: 0
Latest comments: