Advertisement
To reverse
1. Remove the top hinge pin using a 1/8"
the door
2. Lift the door off the bottom hinge.
3. Replace the hinge pin in the top hinge.
4. Switch the top and bottom hinges and
5. Insert the plug buttons into the old
6. Unscrew the light trigger from the
7. Before turning the door upside down,
8. Remove the top hinge pin using a 1/8"
9. Turn the door upside down and place
10.Install the top hinge pin into the door
11.Open and close the door to test the door
12.Remove the old nameplate and stick the
Allen wrench.
move them to the other side. If shims are
behind the hinges, move them with the
hinges. See illustration.
hinge holes.
bottom of the door. Insert the screws,
that were packed with this Use and Care
Guide, into the light trigger holes.
new holes will need to be drilled for the
light trigger. Be careful not to drill down
more than 1/2" or you may damage the
door glass. Measure 12
1
side and make a mark. Measure 3/4"
over from the first mark and make a
second mark. Measure 11/16" in from
the front edge of the door and make a
mark. See illustration. This is where the
new holes will be drilled using a 5/32"
drill bit. Install the light trigger.
Allen wrench.
the door on the bottom hinge pin.
with the Allen wrench.
swing. If the door drags and does not
close evenly, loosen the hinge screws and
slip shims behind the hinge. If shims are
already behind the hinges, readjust
them. Tighten screws and test again.
new Monogram nameplate on the door
using the template included
Reversing the Door Swing
/
" from the right
4
Top of the Door
.
Wine Chiller
Slip Shim
Behind Hinge
Light Trigger
3/4"
11/16"
/
12
1
4
Front of the Door
Top
Hinge
Bottom
Hinge
"
13
Advertisement
