An Overview Of The Socket Panel - Bang & Olufsen UG4 Manual

6
You can connect DVD 1 to your tele vision via
the socket panel on the rear of DVD 1.
Please consult the User's Guides enclosed with
externally connected equipment to ensure
that it is connected in the proper manner.
>> Set up DVD 1
MAINS CTRL
Overview of the rear socket panel
~ (mains)
Socket for connection to the mains.
SERVICE
For use by qualifi ed service personnel only.
LINE OUT R VIDEO
LINE OUT L DIG. OUT
Audio signals are sent from DVD 1 to your television
via these four sockets. All four sockets are used
when you connect DVD 1 to a Bang & Olufsen
television which does not use a 21-pin video cable.
The DIGITAL OUTPUT socket is also used when
connecting DVD 1 to any Bang & Olufsen television
equipped with a Dolby Digital surround sound
module.
AV
21-pin socket for connection to the Bang & Olufsen
television.
CTRL S-VIDEO
Video signals are sent from DVD 1 to your television
via these sockets. The sockets are used to connect
DVD 1 to a Bang & Olufsen television which does
not use a 21-pin video cable.
LINE OUT R VIDEO
SERVICE
LINE OUT L DIG. OUT
The switch options
CVBS
This switch setting is used when you connect DVD 1
to an AV 9000, BeoVision LX, BeoVision MS or
BeoVision MX 4000/4002/6000/7000 television.
Y/C
This switch setting is used when you connect DVD 1
to a BeoVision Avant 50 Hz television.
RGB
This switch setting is used when you connect DVD 1
to any other Bang & Olufsen television.
AV S-VIDEO
CVBS
RGB
Y/C