Table Of Contents - Kenwood DVR-5070 Service Manual

DVR-5070
CONTENTS / ACCESSORIES / CAUTIONS
Contents
CONTENTS / ACCESSORIES / CAUTIONS............. 2
BLOCK DIAGRAM ......................................................3
CIRCUIT DESCRIPTION ............................................4
WIRING DIAGRAM .....................................................9
PC BOARD ...............................................................10
Accessories
FM indoor antenna (1)
(T90-0882-08)
Batteries (LR03/AAA)(2)
Cautions
Operation to reset
The microcomputer may fall into malfunction (impossibility to
operate, erroneous display, etc.) when the power cord is un-
plugged while power is ON or due to an external factor. In this
case, execute the following procedure to reset the microcom-
puter and return it to normal condition.
Caution on condensation
Condensation (of dew) may occur inside the unit when there is
a great difference in temperature between this unit and the out-
side.
This unit may not function properly if condensation occurs. In
this case, leave the unit for a few hours with the power left ON,
and restart the operation after the condensation has dried up.
Be specially cautious against condensation in a following
circumstance:
When this unit is carried from a place to another across a large
difference in temperature, when the humidity in the room where
this unit is installed increases, etc.
Note related to transportation and movement
Before transporting or moving this unit, carry out the fol-
lowing operations.
1 Remove the disc from the unit.
2 Press the 6 key.
3 Wait a few seconds and turn the unit OFF.
2
SCHEMATIC DIAGRAM .......................................... 15
EXPLODED VIEW ....................................................28
PARTS LIST..............................................................29
SPECIFICATIONS ......................................Back cover
Loop antenna(1)
(T90-0896-08)
Remote control unit (1)
(A70-1582-08)
Set the POWER switch to ON (set to Standby mode).
Then press the ¢ key, 4 key and STOP key in this
order.
÷ Please note that resetting the microcomputer clears the
contents stored in and returns and to condition when it left
the factory.
Memory backup function
Stored contents which are
cleared in at least a week after
power plug is unplugged from
power outlet.
Video cord(1)
(E30-1427-08)
Amplifier section
Last input selection
Volume control value
Surround setting
Tuner section
Receiving band
Frequency
Preset stations
Tuning mode setting
DVD section
Menu setup
Power status
Speaker cord(5)
(E30-7271-08): RED
(E30-7272-08): WHT
(E30-7273-08): GRN
(E30-7274-08): GRY
(E30-7275-08): BLU