Panasonic NN-GD692 Important Safety Instructions Manual page 17

Operation
The Sensor Cooking features enable you to cook a variety of foods without having to select the power level or cooking time
as the foods are automatically cooked by detecting a build-up of steam on the humidity sensor. As foods cook in a microwave,
steam is produced. When foods are covered, the steam will build up and escape from the dish and burst. This burst of steam
is detected by the humidity sensor and then the oven automatically calculate the remaining cooking time. All you need to do is
to select the cooking category.
For best results on Sensor Cook, follow these recommendations:
1. The room temperature surrounding the oven should be below 35 °C.
2. Be sure the glass tray, the outside of the cooking containers and the inside of the microwave are dry before placing food in
the oven. Residual beads of moisture turning into steam can mislead the sensor.
3. Food should always be covered loosely, but completely, with plastic warp. (Do not use any snap closing lids.)
4. DO NOT open the oven door until 2 beeps sound and cooking time appears in the display Window. Doing so will cause
inaccurate cooking since the steam from food is no longer contained within the oven cavity. Once the cooking time begins to
count down, the oven door may be opened to stir, turn, or rearrange foods.
5. All food should have a covered stand time of at least 3 to 5 minutes.
6. DO NOT use if oven cavity is warm (from previously cooked foods).
IP4223_39X90HP_Eng_23_120626.indd 17 IP4223_39X90HP_Eng_23_120626.indd 17
(To Cook Food Using Sensor Cook)
1. Put the food into the oven
2. Press Sensor Cook Button
Select until the desired number of category appears in the Display
Window.
3. More/Less Dial (Optional*):
Preferences for food doneness vary with each individual. After using
Sensor Reheat for a few times, you may decide the doneness of food.
By rotating the More/Less dial, the programs can be adjusted to cook
food for longer or shorter time.
*If you are satisfied with the result of the Sensor program, you don't
have to use this dial.
4. Press
After the heat and humidity is detected by the SENSOR the oven will
beep twice, the remaining time appears in the Display Window and
begins to count down.
- Eng-17 -
2012-6-26 16:05:56 2012-6-26 16:05:56