Cleaning And Maintenance - Bosch B25L TDS25PRO1 Operating Instructions Manual

en
Use the concentrator (21) to direct the steam jet
at the stain, in direction from the outer side of
the garment into the fabric placing a sponge or
cloth underneath it to absorb the dirt. The brush
extension (22) can also be used with gentle action
to support the cleaning effect.
If the above does not solve the problem, get
in touch with an authorised technical service
centre.
«Calc'n clean» (E)
Cleaning the Boiler
To extend the life of your steam generator and to
avoid any build up of scale, it is essential that you
rinse out the boiler after several hours of use. If your
water is hard, increase the frequency.
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
Approximately after 50 hours of use, «Calc´n clean»
pilot light (9) will light up indicating that boiler must
be rinsed.
1. Check that the appliance is cold and unplugged
for more than 2 hours, and that the removable
water tank (1) is empty.
2. Place your appliance on the edge of your kitchen
sink.
3. Unscrew the boiler drainage plug located on the
bottom of the appliance using a coin.
4. Holding your steam generator in upside down
position, and using a jug, fill the boiler (in the
base unit) with 1/4 litre of water
5. Shake the base unit for a few moments and then
empty it completely over a sink or bucket. To
obtain the best result, we recommend that this
operation is done twice
6. Important: before re-closing, make sure no water
remains in the boiler.
7. Replace and tighten up the boiler drainage plug
with a coin
To reset «Calc´n clean» pilot light and hours counter,
switch the station off twice, keeping it off during at
least 30 seconds each time
14
Intelligent steam
This ironing system has intelligent steam control,
which provides additional steam depending on the
user demand.
Cleaning & Maintenance
1. After ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cloth.
3. If the soleplate is soiled with dirt or scale, clean
it with a damp cloth.
4. Never use abrasive products or solvents.
Important:
• Always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
Storing the appliance (D)
1. Always allow the appliance to cool down before
storing it.
2. Set the switches for main power and steam
boiler to the «Off/Stop» position and disconnect
the connection.
3. Place the iron on the iron pad, standing on the
soleplate.
4. Empty the water tank and store the mains cable
on the cord rewind facility. Tidy the steam hose
on the handle of the iron using the cord clip
provided (14). Do not wrap the cords too tight.