Table of Contents
Advertisement
I n ser t ing a n d rep l aci n g batterie s
Inserting method
1. Move up the switch and open the cover.
2. Raise the battery holder and insert the battery.
Battery
Be careful with the
battery direction.
Replacement method (hot swap)
The battery can be replaced without turning off the power.
1. Hold the button
The power LED starts blinking. After a few seconds, it switches to the slow blinking state with
intervals of approximately 2 seconds.
Hold down the button for a while.
2. Remove the used battery. Then within 15 seconds, insert the charged battery. When the hot
swapping succeeds, the power LED starts blinking in 2-second intervals again. If the hot
swapping fails, the power LED turns off.
3. Press the button
Resume the paused application from where it is stopped.
Switch
Cover
Battery holder
(the foremost button) for longer than 1 second.
Power LED
(the foremost button).
* The manufacturing number is provided at the
inserting section of the battery (cover section).
13
Advertisement
Table of Contents
