Advertisement
QQ
3 7 63 1515 0
How to enter the test mode
While pressing and holding the Preset 1 and Preset 3 keys,
reset the unit.
How to exit from the test mode
While holding the Preset 6 key, reset the unit.
Note : Turning ACC off, power off, momentary power down
or panel detaching does not terminate the test mode.
Initial status in the test mode
• Sources : ALL OFF
• Display : All segments are lit.
• Volume : -10dB (displayed as "30")
• Loudness : OFF
• CRSC : OFF regardless of the presence of switching func-
tion.
• SYSTEM Q : Flat
• WOW : All OFF
• BEEP : When pressing any keys, the buzzer generates a
beep at any time.
• AUX : ON
• MENU SYSTEM Q : OFF
TE
L 13942296513
• Variable model : Default is white
• Multifunction : Source dependency (Preset, SCAN, etc.)
Special display in Tuner mode
When any of the following messages is displayed in Tuner
mode, the F/E may be abnormal.
• "TNE2P NG" : The EEPROM is set to the default (unstable
values) because the F/E was shipped without passing
through the adjustment process, etc.
• "TNCON NG" : Communication with the F/E is not possible.
Forced switching of K3I
Each press of the Preset 6 key in Tuner mode should switch
K3I from AUTO→Forced Wide→Forced Middle→Forced
Narrow→AUTO.
The initial status is AUTO and the display shows these
modes as follows.
• AUTO : FMA
• Forced Wide : FMW
• Forced Middle : FMM
• Forced Narrow : FMN
www
.
TEST MODE
x
ao
u163
y
i
2 9
8
Test mode specifications of the CD receiver
• Forced ejection is inhibited in the reset start operation. When
the unit is reset while a CD is loaded in it, resetting does
not recognize the CD.
• Each press of the Track Up key jumps to the following track
numbers :
No. 9→No. 15→No. 10→No. 11→No. 12→No. 13→No. 22
→No. 14→No. 9 (The cycle restarts from here.)
• Each press of the Track Down key jumps to the previous
track number to the track being played.
• When the number of total trucks of the MP3 disc or the
WMA disc is less than 9, 1st truck is played.
• When the disc media is CD, A short press of the Preset 1
key jumps to the track number 28.
• When the model is equipped the CD mechanism assembly
adapted for MP3 or MP3/WMA disc, the mechanism name
and version number are displayed during the FL model is
lower stand and Display mode of LCD model is DNPS.
Audio-related specifications (Model KDC-X979/
9026R/PSW9527/W9027)
Q Q
• Pressing the
key on the remote initiates the audio adjust-
3
6 7
1 3
1 5
ment mode.
• BL/F key on the Fader initials.
• Continuous holding of a remote control key is inhibited, and
workings are short press of any keys.
• Balance is adjusted in 3 steps of L15 / 0 / R15 with the
Track Up/Down keys (Default value at 0).
• Fader is adjusted in 3 steps of R15 / 0 / F15 with the Track
Up/Down keys (Default value at 0).
• HPF is adjusted in 2 steps of OFF / 170Hz (or 220Hz) with
the Track Up/Down keys (Default value at OFF).
• LPF : (Default value at through).
• Each press of the PRO LOGIG II key should switch in Bass
management control.
Menu-related specifications
• A short press of the Q key initiates the menu mode.
• Pressing the DNPP key on the remote initiates the Menu
mode.
• Continuous holding of a remote control key is inhibited, and
workings are short press of any keys.
• Contrast is adjusted in 3 steps of 0 / 5 / 10 with the Track
Up/Down keys (Default value at 5).
co
.
KDC-9026R/PSW9527
KDC-W9027/X979
9 4
2 8
0 5
8
2 9
9 4
2 8
m
9 9
9 9
13
Advertisement
