Table of Contents
Advertisement
2 = dynamic of filtered data from the wind sensor (use that mode with HR Masthead unit <
V1.7 and Masthead unit)
The default setting is « 0 ».
GyroPiWindComp: enables wind data dynamic correction for use by the autopilot.
The default setting is « Y » (on).
Datalog
ValidDatalog : enables the data log on the embedded USB key.
The default setting is « Y » (on).
3Dhull
3DH_Valid: enables the « NMEA1/Compass » input.
The default setting is « Y » (on)
3DH_install: allows selection of 3Dhull sensor.
255
= Auto detection
0
= NMEA 183 compass
1
= 3Dhull V1
6
= 3DhullGPS V1
7
= 3Dhull V2
9
= 3DhullGPS V2
10
= REGATTA compass
11
= KVH compass
The default setting is « 255 » (auto detection).
3DH_baudrate: allows adjusting the NMEA baud rate when a compass is connected to
« NMEA1/COMPASS » and 3DDH_install is not on « 255 » (auto detection).
The default setting is "4800" bauds.
NmeaIn
ValidNmeaIn : enables NMEA2 input.
The default setting is « Y » (on)
ValidUdpNmeaIn : enables the UDP connection between the PC and the Processor
input. The NMEA input, ValidNmeaIn must be « n » (off) for this mode.
The default setting is « Y » (on)
UdpNmeaInPort : this is the input port address for UDP connection.
The default setting is « 1001 »
NmeaOut
ValidNmeaOut : enables NMEA output on NMEA2 port.
The default setting is « Y » (on)
NmeaOutBaudrate : allows setting the baud rate on both input and output of NMEA port
(NMEA2).
The default setting is "4800" bauds.
ValidUdpNmeaOut : enables the UDP output from the Processor to the PC. NMEA output
must be of for this mode (ValidNmeaOut = « n »).
19
33-60-084-001 PROCESSOR REGATTA Manual
Advertisement
Table of Contents
