Kuchef JK-108 Instruction Manual page 7

General Safety Instructions (Cont.)
• Filling: Lift the kettle off the power base to fill it. Never fill the kettle while it
sits on its base or while it is switched on. If the power base unit becomes
wet, unplug it before wiping it dry.
• Do not overfill: To avoid splattering of boiling water, do not overfill the kettle.
Make sure the water level is between the minimum and maximum levels.
• Spout: Position the kettle so the spout is directed away from you.
• Filter: Do not operate the kettle without the filter fitted. Never leave the filter
loose in the kettle, it must sit securely in place in front of the spout. Never
remove or refit the filter when the kettle contains hot water.
• Before switching on: Before turning on the power, make sure the kettle is
located properly on the power base and the lid is securely closed, otherwise
it may not switch off.
• Unattended: Do not leave the kettle unattended when the power is turned on.
• CAUTION:
Ensure the kettle is switched off before removing it from the base.
Do not move the appliance while it is switched on.
• Disconnect: Always unplug the kettle from the outlet when it is not in use.
To disconnect, turn off the power at the outlet, then remove the plug from the
wall. Grip the plug when disconnecting, do not pull the cord.
• Cleaning: Unplug the kettle and allow it to cool before cleaning and mainte-
nance. Do not use abrasive or alkaline cleaning agents to clean this appliance.
CAUTION: HOT!
• Kettle surfaces: Do not touch any part of the kettle housing when it is in use.
The stainless steel and glass surfaces get hot. Only touch the handle. Do not
put any part of your hand or body near the kettle when it is turned on.
• Water: After boiling, water can remain hot for a considerable time and can
present a scald hazard.
• Residual heat: Take care when handling the kettle after use. The inside
surface which conceals the heating element is subject to residual heat.
• Lid: Ensure that the lid is and remains closed while the water is boiling or
straight afterwards. Scalding may occur if the lid is removed while the water is
heating up. Be careful when opening the lid for refilling when the kettle is hot.
• Steam: While water is boiling, or just after the water has finished boiling, avoid
contact with the steam from the spout.
• Moving: Use extreme caution when moving the kettle containing hot water.
• Pouring: Always take care when pouring hot water. Tilt the kettle slowly and
carefully without tipping it too fast.
AFTER SALES SUPPORT
AUS 1300 886 649
info@tempo.org
MODEL: JK-108 PRODUCT CODE: 51373 10/2015
7