Led Setting (Dip 1); Single/Dual Edge Processing (Dip 2) - Paradox MG-PMD85 Reference & Installation Manual

The
the 2.1m (7ft) mounting height only.
Ensure that the unit's front and back cover
are tightly joined together without any
spacing (around the rim of the unit) before
tightening the screw, otherwise the
weatherproof casing may be compromised
and moisture may enter the unit.

LED Setting (DIP 1)

This option enables or disables the red LED. The
red LED will illuminate for a period of four
seconds to indicate detected movement. The
motion detector performs a battery test every 12
hours. If the battery voltage is too low, the red
LED will flash at eight-second intervals and the
motion detector will send a low battery signal to
the receiver. A trouble will then be generated and
transmitted to the central monitoring station. The
red LED will flash rapidly when the motion
detector transmits a signal to the receiver.
DIP switch 1 OFF = LED deactivated
DIP switch 1 ON = LED activated (default)

Single/Dual Edge Processing (DIP 2)

This option determines the DSP (Digital Signal
Processing) of the detector. Single Edge
Processing should be used in normal
environments with minimal sources of
Reference & Installation Manual
MG-PMD85
has been UL evaluated at
3n