Product View; Charging Mediashare; Installing Storage Devices; Sd Memory Card - Verbatim MediaShare Operating Instructions Manual

Product View

9
8
COMPONENT DESCRIPTION

1. Battery Green ON: The battery charge is more
Level LED than 30%.

Red ON: The battery charge is between
10% and 30%.

Red Fast Flashing: The battery charge is
depleted and the unit will soon shut down.

Green Slow Flash (every 2 seconds): The
battery is charging.

Green Slow Flash (every 1.5 seconds):
The device is shutting down.

LED off: The device is powered off.
2. Read / Write During Wi-Fi disk mode:

LED Blue ON: Memory connection is
successful.

Blue Flashing: Memory is reading or
writing.
During Card reader mode:

Blue ON: Connected to USB2.0

Blue Flashing: Connected to USB2.0 and
is reading or writing.
3. Wi-Fi LED Blue LED shows the Wi-Fi connection state.

Flashing indicates that initiation is in
process.

ON indicates Wi-Fi initiation has
completed.

The LED is OFF for the following
situations:




4. Internet Green: Connected to Internet via the
LED bridge.

Off: Not connected to the Internet.

5. USB Host Insert a USB flash drive or USB hard drive
Port for Wi-Fi access.

In Power Off mode USB port can be used to
charge connected smartphone or tablet.
6. Reset Insert a small tool (such as a paperclip) to press
Button the button and reset the device to Factory
Default configuration.
7. SD Card Insert an SD card for Wi-Fi access. Insert a
Slot microSD card using appropriate adapter.

8. USB Device Use the included USB cable to connect to a
Port computer over USB 2.0 to enable data
transfer.

Use the included USB cable to connect to a
USB port or USB charging adaptor to
charge the device
9. Power Turns the device on/off.
Button
User Manual for iOS
1
2
3
4
5
6
7
Device is on, but the Wi-Fi signal is
weak.
Device is off.
Device is in Mobile Mode but the
Wi-Fi is off.

Charging MediaShare

Using the supplied cable connect MediaShare to a
powered USB port or USB charger in order to charge
the built in battery. It may take up to 7 hours to fully
charge the battery.

Installing Storage Devices

MediaShare contains no internal storage. You must
attach either an SD Card or a USB storage device
before you are able to use MediaShare with your
smartphone or table.
Once your SD Card or USB storage device is attached,
MediaShare will reserve up to 200MB of its capacity for
temporary files and other system functions. Therefore
this space is not available for user data.
MediaShare supports storage devices using FAT,
FAT32, exFAT (for SDXC), or NTFS file systems.
Note: Prior to installing the SD
Memory Card or USB Device,
make sure MediaShare
WIreless is turned off.
Do not touch the exposed
connectors on your SD Memory
card.

SD Memory Card

Locate the SD memory card slot. Insert the memory
card. Gently push the memory card all the way in until it
locks into its place.

USB External Storage

Locate the USB host port on the device. Insert a USB
drive or portable hard drive cable into the USB port.
4