Technical Information; Troubleshooting - EDIFIER TickTock Bluetooth-MF240BT User Manual

Technical information

Total power: RMS 4W × 2(THD + N=10%, f0=1KHz)
Signal to noise rate: ≥90dBA
Distortion: ≤ 0.5%
Frequency response: 90Hz-20KHz
Input sensitivity: 850mV ± 50mV
Speaker units: 1½" (40mm), magnetically shielded, 8 Ohms
Input type: FM / Bluetooth / AUX
FM Preset: 24 preset channels
Region selections: EU / ASIA / US / AUS (87.0-108.0MHz),
JAP (76.0-90.0MHz), FULL (76.0-108.0MHz)
Alarms: 5 independent
Alarm sound time: 5 minutes
Snooze time: 10 minutes, max snooze repeat times: 3
Sleep timer options: 15, 30, 45, 60, 75, 90 minutes
Product dimension: 130 x 126 x 89mm
Weight Net /Gross: 0.5Kg / 0.6Kg
8
English
Not all speakers function:
Please first check if the speaker wires are connected securely; then check if the Line-in connectors are
reversed; check also if the audio source is at fault.
After speaker automatically reconnects to the last connected USB Bluetooth soundcard, no music output from speaker system.
Since some of the USB Bluetooth soundcard driver will not automatically enable SBC codec, please press and hold the FUNC
button to disconnect with the soundcard, then set up the connection again from PC.
After speaker automatically reconnects to the last connected USB Bluetooth soundcard, no music
from speaker system：
Since some of the USB Bluetooth soundcard driver will not automatically enable SBC codec, please press and hold the FUNC
button to disconnect with the soundcard, then set up the connection again from PC.
One satellite speaker does not function when playing CD from computer:
This kind of phenomena is prone to happen on new computer systems that one satellite does not function
when playing CD, but system works fine when playing WAV formatted files. This is mainly due to the fault
connection of CD-ROM and sound card, that one channel of signal is shorted to the ground.
Please refer to the manual of CD-ROM and sound card to adjust the wire connection.
System does not work at all:
1. Please check if power is connected, and if the wall outlet is switched on.
2. Please check if system is in STBY mode.
3. Please check if the master volume is turned to minimum
4. Please check if the audio input cable is connected correctly
5. Please check if there is signal from audio source
If you have any further questions or concerns regarding Edifier Products:
Please visit our website at: www.edifier.com, or email Edifier Support for further assistance at: main@edifier.com,
If you prefer, you may contact us by phone, Toll Free: 1-877-EDIFIER (334-3437).

Troubleshooting

9
English