Makita LC1230 Technical Information page 4

Dismounting of gear
1. Take off 2 ball bearings 6000 from the gear housing R.
2. Take off gear complete 16-44 from the gear housing R. However the ball bearing 6000LLB
remains in the gear housing R.
3. Put the gear housing R on the U-cut part of arbor press table, and press the spindle with the
arbor press. Then the spindle and ball bearing 6202LLB can be dismounted from the gear housing R.
4. Take off the ball bearing 6000LLB from the gear housing R.
Mounting of gear
Carry out the above process in the inverse order
Ball bearing 6000
Mounting of safety cover
1. Insert the hex socket head M4 into the hole on the safety cover and mount the torsion spring on the
place illustrated below.
2. Mount the center plate adjusting its holes with hex socket head bolt M4 and the boss on the
safety cover.
3. Fasten center washer, center cover and center support on the place illustrated below, with
tapping screw.
Boss of sefety cover
Gear housing R
Ball bearing
6000LLB
Center plate
Hex. socket
head bolt M4
Tortion spring
Arbor press
table
Spindle
Ball bearing 6202LLB
Helical gear 38
Center cover
Center support
Center washer
Tapping screw