Chevrolet kodiak 2004 Owner's Manual page 94

Two-Speed Rear Axle Electric
Shift Control
If your vehicle is equipped with this feature, you'll find a
label on the headliner above the windshield or in
another place near the driver that shows how to use it.
Be sure to follow the directions carefully.
Use the following directions based on the type of shift
control you have.
Manual Transmission
When the switch is up, the rear axle is in the high
range. Push the switch down to change to low range.
2-26
The rear axle shift control
switch for a manual
transmission is located on
the shift lever.
The two-speed axle should be in low when you park the
vehicle. You'll need to engage the transmission, even
move the vehicle a little, to be sure the axle is in the low
range. Then apply the parking brake, shift into
NEUTRAL and shut off the engine.
Also, always start the vehicle in motion with the
two-speed axle in the low range. To shift up from low to
high, do the following:
1. Move the switch up for the high range,
2. disengage the clutch, and
3. after a brief pause, engage the clutch and then
press down on the accelerator.
To shift down from high to low, do the following:
1. Move the switch down to low,
2. release the accelerator and then quickly apply
it again.