Table of Contents
Advertisement
About reversing the door.
GEApUio.ces.co
Reversing
the Door
Tools needed.
[] Standard #2
[] Tape-tipped
Phillipsscrewdriver
putty knife
r-_ open the door and remove the filler plugs opposite the
hinges. With the door completely open, remove the bottom
screw from each hinge on the dryer face. Insert these
screws about half way into the TOP holes, for each hinge,
on the opposite side (whereyou removed the filler plugs).
Apply firm pressure to get the screw started in new holes.
[]
Loosen top screw from each hinge on the dryer face half
way. With one hand holding the top of the door and the
other hand holding the bottom, remove the door from the
dryer by lifting it UP and OUT.
[]
Remove the blind plate from the hinge side of the dryer by
removing its two screws. Remove the strike plate from the
opposite side of the dryer by removing its two screws.
Reinstallthe plates, on the opposite sides,using two screws
in each plate.
[_ Rotate the door 180°.Insert it on the opposite side of the
opening by moving the door IN and DOWN until the top
hinge and the bottom hinge are resting on the top screws
inserted in step 1.
REMOVE 4 PLUGS AND
KEEP
FOR INSERTION
INTO
__THE OPPOSITE SIDE
REMOVE BOTTOM SCREW FROM EACH HINGE
AND INSTALL HALF WAY INTO EACH TOP OF
oPPOSiTE
H NGE
HOLES
LOOSEN EACH TOP HINGE
__I__""A'_"-_
_
EWo Lu WAZ20 ;L'FT
m-
.....
STRIKE
BLIND
PLATE
PLATE
ROTATE DOOR 280 ° AND HANG
IT ON TOP HINGE SCREWS
[_ Removethe remaining screws from the side of the opening
from which the door was removed. With these screws,
secure each hinge at the bottom. Tighten the two top screws
of each hinge. Reinsert the plastic plugs on the side from
which the door was removed.
INSTALL AND TIGHTEN BOTTOM
_N
SCREWSANDTIGHTEN
TOP
, /
INSERTPLUGS
INTO HOLES ON
Advertisement
Table of Contents
