Assembly - Weslo PERSUIT 695i User Manual

ASSEMBLY

Place all parts of the PURSUIT 695i in a cleared area and remove the packing materials. Do not dispose of
the packing materials until assembly is completed.
Assembly requires the included allen wrench
adjustable wrenches
1. Press the Side Shield Cover (30) onto the Left and
Right Side Shields (1, 2).
Insert the Seat Post (20) into the Frame (15). Make
sure that the Seat Post Bushing (23) is inserted fully
into the Frame. Align one of the holes in the Seat
Post with the hole in the Frame. Insert the Seat
Knob (29) into the Frame and the Seat Post, and
tighten the Seat Knob into the Frame. Make sure to
insert the Seat Knob through one of the holes in
the Seat Post; do not insert the Seat Knob
under the Seat Post.
Attach the Seat (19) to the Seat Post (20) with three
M8 Nylon Locknuts (21) and three M8 Split Washers
(53). (Note: The Nylon Locknuts and Split Washers
may be pre-attached to the bottom of the Seat.)
2. The Console (7) requires two AA batteries (not
included). Alkaline batteries are recommended.
Refer to the inset drawing. Locate the battery com-
partment on the back of the Console. Press two bat-
teries into the battery compartment. Make sure that
the negative ends of the batteries (marked "–")
are touching the springs in the battery compart-
ment.
Insert the console wire through the Handlebar Post
(14). Connect the console wire to the Reed Switch
Wire (54). Attach the Console (7) to the Handlebar
Post with four M4 x 16mm Screws (9).
Carefully slide the Handlebar Post (14) onto the
Frame (15). Be careful to avoid pinching the
wires inside the Handlebar Post. Attach the
Handlebar Post with three M10 x 25mm Button
Screws (8) and three M10 Split Washers (31).
Attach the Knob Housing (12) to the Handlebar Post
with an M4 x 16mm Screw (9).
.
6
, a phillips screwdriver
1
53
21
23
30
2
7
Console
Wire
9
54
31
8
, and two
19
53
21
20
29
15
1
2
7
Batteries
12
9
14
8
31
8
15