Audiovox DST 961 Owner Operating Instructions page 8

~
-0
-0- -00- -.
-into the holes on the bottom of the base.
Position the power cord to extend down
the wall the phone is to be mounted on.
Slide the base down on the mounting
studs until it locks into place.
3. Connect the telephone lIne cord. The
telephone line cord has a snap-in plug at
each end. Insert one of the plugs into
the jack on the bottom of the base. In-
sert the other end of the plug into the wall
jack.
4. Plug the AC adaptor into an electrical
outlet and the DC connector on the back
of the Base Unit.
using such a plate, you should start with tha
next section, USING THE WALL MOUNT
ADAPTOR.
1. Choose a spot near an electrical outlet
and a telephone jack.
v/')ur phone requires a modular telephone
i lnd a standard electrical outlet (120v
k",l. The power cord is six feet long; make
sure there is an electrical outlet within reach
of the base. The outlet should not be con-
trolled by a wall switch. If the switch is ever
turned off, the phone will not operate.
USING THE WALL MOUNT ADAPTOR
1. Position the wall mount bracket on
the base. Une up the tabs on the wall
mount adaptor with the holes on the
bottom of the base. Snap the wall mount
bracke~ firmly in place.
2. Mount th~ case on the wall. Position
the base so the mounting studs will fit
-~
I-F