Table of Contents
Advertisement
4.
5.
6.
-Or-
Connect the other end of the DMX cable
(male plug) to the professional DMX
controller.
Take care that you always place the
controller in such a position that the operator
has full view of all the connected machines.
Consult the DMX controller manual for
instructions and safe use.
To turn on the machine put the switch of
the DMX FX Switch Pack in the 'on'
position.
The display will show the image on the
left for 1 second.
Before you start using the DMX FX
Switch Pack you must perform the
correct DMX FX Switch Pack set-up.
During installation, make sure that you use
free channels on the DMX controller and
that these channels are in the safe mode.
Consult the manual of the DMX controller for
the set-up.
Press the 'MODE' button to start the set-
up of the DMX FX Switch Pack.
The DMX FX Switch Pack now gives you
two set-up options.
Set addresses by sequence
You only need to set the Safety address and
the first output address, whereas the other 3
output addresses are automatically set in
numerical order.
Set addresses individually
You set all 5 addresses yourself
Change to the required mode by
pressing on the ▲ or ▼ button. Then
press the 'MODE' button to confirm your
choice.
Version 1.0
Page 12
Advertisement
Table of Contents
