Subwoofer Connections - Phase Technology Solaris ATS-1 Owner's Manual & Installation Instructions

SUBWOOFER CONNECTIONS

You may choose to use a subwoofer with your ATS-1 to enhance the bass response of your music system. The
Phase Technology Power 8 is well-suited for the use with the ATS-1. There are two ways to connect the ATS-1 in a
home theater system with a powered subwoofer. The LOW-LEVEL diagram below may be utilized with receivers or
processors that feature subwoofer or low frequency outputs. This type of output utilizes RCA connectors.
Note: Most processors and receivers have a single (mono) sub-out. Connect the subwoofer output from your
receiver/processor to either the left input or the right input on your subwoofer amplifi er.
The HIGH-LEVEL (speaker level) diagram below illustrates the typical subwoofer wiring utilizing the speaker output
terminals of the amplifi er or receiver. This hook-up method illustrates the ATS-1 connection to the subwoofer.
LOW-LEVEL SUBWOOFER HOOKUP
RECEIVER/PROCESSOR
L R LA
LINE LINE
OUT IN
L
R
SUBWOOFER
AMPLIFIER
L R
INPUT
OUTPUT
RA
LEFT SPEAKER
HIGH-LEVEL SUBWOOFER HOOK-UP
AMPLIFIER MAIN SPEAKER OUTPUTS
L
LINE LINE
OUT IN
L
R
L R
4
R
RIGHT SPEAKER
SUBWOOFER
AMPLIFIER
INPUT
OUTPUT