LG K1 Service Manual page 38

When the Supervisor Password is set, the new item User Access Level and Password Check will be
added in the menu. You can make further settings of access right in the User Access Level item. Setting
options: No Access, View Only, Limited and Full Access. The Password Check item is used to specify
the type of BIOS password protection that is implemented. Settings are described below:
Setup The password prompt appears only when end users try to run Setup.
Always A password prompt appears every time when the Notebook is powered on or when end users
try to run Setup.
To clear a set password, just press [Enter] when you are prompted to enter the password. A message
box will show up confirming the password will be disabled. Once the password is disabled, the system
will boot and you can enter Setup without entering any password.
Note
About Supervisor Password and User Password
Supervisor Password allows the user to enter and change the settings of the setup menu; User Password
only allows the user to enter the setup menu, but do not have the right to make changes.
Ch3. System information
37